SECTION I. MATERIAL IDENTIFICATION

Chemical Name Trade Name P5011 CURABLE

and Synonyms: PVC PLASTISOLS and Synonyms: REDUCER

Chemical Family: POLYVINYL CHLORIDE Formula: MIXTURE

SECTION II INGREDIENTS AND HAZARDS

Ingredient: | % | Hazard Data:

PVC RESINS |10-90| NOT HAZARDOUS IN LIQUID FORM

PHTHALATE PLASTICIZERS |10-90| NOT HAZARDOUS

EPOXY SOY | 2-90| NOT HAZARDOUS

ZINC STABILIZERS | 0- 6| NOT HAZARDOUS

SECTION III PHYSICAL DATA

Boiling point at 1 atm, deg F:>400 DEG F. Specific gravity (H20=1): 1.2

Vapor pressure at (mm Hg):<1.2 @ 200 DEG C. Evap. Rate (BuAc =1): N/A

Vapor density (Air=1): 16 Volatiles, % by Volume: 0

Water solubility: NIL Molecular weight: N/A

Appearance & Odor: Milky liquid. PHTHALATE ODOR.

SECTION IV FIRE AND EXPLOSION DATA

Flash Point & Method: > 500 DEG F. Solidifies Autoignition Temp.: N/A

Flammability Limits in Air: N/A Upper: N/A Lower: N/A

Extinguishing Media: DRY POWDER, CARBON MONOXIDE, CHEMICAL FOAM.

Special Fire fighting procedures: SELF-CONTAINED BREATHING APPARATUS.

Unusual fire and explosion hazards: COOL DRUMS WITH WATER SPRAY. HYDROGEN

CHLORIDE GASES EVOLVED WHEN BURNING.

SECTION V HEALTH HAZARD INFORMATION | TLV

Effect of Overexposure: EXCESSIVE HIGH TEMPERATURE MAY PRODUCE IRRITATING VAPOR. DURING NORMAL HEAT PROCESSING, A SMALL AMOUNT OF VAPOR WILL BE EVOLVED.

RESPIRATORY PROBLEMS MAY OCCUR WITHOUT ADEQUATE VENTILATION.

FIRST AID:

Eye Contact: FLUSH WITH WATER FOR 15 MINUTES

Skin Contact: WASH WITH SOAP AND WATER

Inhalation: REMOVE TO FRESH AIR IF EXCESSIVE FUMES INHALED. GIVE

OXYGEN IF NECESSARY.

Ingestion: CONSULT PHYSICIAN

SECTION VI. REACTIVITY DATA

Stability: |stable | X |

|unstable | | Incompatibility:(Materials to avoid) STRONG OXIDIZING AGENTS.

Conditions to avoid: HIGH TEMPERATURES

Hazardous decomposition products: CARBON MONOXIDE, CARBON DIOXIDE, VARIOUS HYDROCARBONS, HYDROGEN CHLORIDE.

Hazardous |may occur | | Conditions to avoid: N/A

Polymerization: |may not occur | X |

SECTION VII. SPILL, LEAK, AND DISPOSAL PROCEDURES

Spills, leaks: (Steps to be taken) ABSORB ON VERMICULITE OR FLOOR DRY. PUMP LARGE SPILLS TO SALVAGE TANK.

Waste Disposal Method: INCINERATE ACCORDING TO LOCAL, STATE AND FEDERAL REGULATIONS.

SECTION VIII. SPECIAL PROTECTION INFORMATION

Respiratory protection: (Specify Type) RECOMMENDED IF NO LOCAL EXHAUST

Ventilation: Local Exhaust: RECOMMENDED FOR HEAT PROCESSING | Special: N/A

|Mechanical (General) RECOMMENDED | Other: N/A

Protective gloves POLYETHYLENE TYPE |Eye protection: SAFETY GLASSES

ALWAYS USE GOOD INDUSTRIAL HYGIENE.

Other protective equipment and precautions:

SECTION IX. SPECIAL PRECAUTIONS AND COMMENTS

Storage & Handling Information: CONTAINERS MAY BE HAZARDOUS WHEN EMPTIED DUE TO VAPOR BUILD-UP. STORE BETWEEN 50 - 90 DEG F. AWAY FROM HEAT OR FLAME

Other Precautions: ALL HAZARD PRECAUTIONS IN THE DATA SHEET MUST BE OBSERVED.

DOT Class: NOT REGULATED

|HAZARD IDENTITY |

|Health | 1 |

|Flammability | 1 |

|Reactivity | 0 |

|Contact | B |

Judgments as to the suitability of information herein for purchaser’s purposes are necessarily purchaser's responsibility. Therefore, although reasonable care has been taken in the preparation of such information, QCM Co. extends NO warranties, makes NO representations and assumes no responsibility as to accuracy or suitability of such information for application to purchaser's intended purposes of or for consequences of it's use.

Prepared by: MANAGER TECHNICAL SERVICES