XOLB-102 Cotton White is designed for high volume auto printing on cotton fabrics. XOLB-102 is extremely opaque with excellent mat characteristics, creating the perfect flat base plate and producing prints with outstanding coverage. This smooth, creamy consistency is easy to print with on both manual and automatic presses. The creamy consistency also allows for a very clear screen shear. XOLB-102 is fast flashing, allowing for shorter dwell times and faster production rates. Also works well as a highlight white or a stand-alone white.Instructions:
For best results flood the image and print using a sharp 70 - 80 durometer squeegee. A 65-90-65 durometer squeegee may be used when a very heavy deposit is required. 80-305 TPI (32-120 TPcm) mesh taut screens (25 newtons or higher) are strongly recommended. For smoothest deposit use 160 TPI (62 TPcm) mesh or higher when necessary. Coarse meshes (60-83 TPI, 23-32 TPcm) are recommended for a thicker ink deposit. Heavy fleece may require a thicker deposit.Recommendation:
Stencil: Use any direct emulsion or capillary film.
Additives: XOLB-102 is ready to print. Reduce only if necessary using P-5011 curable reducer. Reducing the viscosity will also reduce the opacity and coverage of the ink. Please test before production run. For printing on nylon mix with MF-66 Nylon Bonding Agent.
Flashing: Parameters vary between all flash units. Flash for 2-3 seconds with the ink deposit reaching 150-250˚F (65-121˚C). Ink should be dry and without tack. WARNING: Over flashing can cure the ink and prevent adhesion between coats of ink.
Curing: Cure at 325˚F (162˚C) over a 60-90 second period depending on oven type and thickness of ink deposit. A thicker deposit will take longer to cure as the heat must penetrate through the entire ink layer.
Cleanup: Use any of the commercially available products for the cleanup of plastisol inks.